2006 Subaru B9 Tribeca Owner's Manual - Page 111
2006 Subaru B9 Tribeca Manual
Page 111 highlights
Keys and doors 2-17 tem may not respond. Emergency disarming If you cannot disarm the system using the transmitter (i.e. the transmitter is lost, broken or the transmitter battery is too weak), you can disarm the system without using the transmitter. The system can be disarmed if you turn the ignition switch from the "LOCK" to the "ON" position with a registered key. Passive arming When passive arming mode has been programmed by the dealer, arming of the system is automatically accomplished without using the remote transmitter. Note that in this mode, DOORS MUST BE MANUALLY LOCKED. To enter the passive mode If you wish to program the passive arming mode, have it done by your SUBARU dealer. Arming the system 1) LOCK 2) ON 1 2 Valet mode When you choose the valet mode, the alarm system does not operate. In valet mode, the remote transmitter is used only for locking and unlocking the doors and rear gate and panic activation. To enter the valet mode, change the setting of your vehicle's alarm system for deactivation mode. (Refer to "Activating and deactivating the alarm system" in this section.) The security indicator light will continue to flash once every three seconds indicating that the system is in the valet mode. To exit valet mode, change the setting of your vehicle's alarm system for activation mode. (Refer to "Activating and deactivating the alarm system" in this section.) 200721 In passive mode, the system will automatically activate the alarm but WILL NOT automatically lock the doors. In order to lock the doors you must either lock them as indicated in step 4 below or with the key once they have been closed. Failure to lock the doors manually will result in a higher security risk. 1. Turn the ignition switch to the "ON" position. 2. Turn the ignition switch from "ON" to "LOCK" position and remove the key from the ignition switch. 3. Open the doors and get out of the vehicle. - CONTINUED -