2006 Subaru B9 Tribeca Owner's Manual - Page 243
2006 Subaru B9 Tribeca Manual
Page 243 highlights
Starting and operating 7-29 To increase the speed (by accelerator pedal) 1. Depress the accelerator pedal to accelerate the vehicle to the desired speed. 2. Push the control lever downward in the "SET/COAST" direction once. Now the desired speed is set and the vehicle will keep running at that speed without depressing the accelerator pedal. To decrease the speed (by control lever) NOTE If the difference between the actual vehicle speed when the control lever is pushed downward and the speed last time you set is less than 4 mph (6.8 km/ h), the vehicle speed will be lowered by 1 mph (1.6 km/h). This occurs because the cruise control system unit regards this lever operation as that intended to decrease the vehicle speed. To decrease the speed (by brake pedal) 1. Depress the brake pedal to release cruise control temporarily. 2. When the speed decreases to the desired speed, press the control lever downward in the "SET/COAST" direction once. Now the desired speed is set and the vehicle will keep running at that speed without depressing the accelerator pedal. Cruise control indicator light 300333 Push the control lever downward in the "SET/COAST" direction and hold it until the vehicle reaches the desired speed. Then, release the control lever. The vehicle speed at that moment will be memorized and treated as the new set speed. When the difference between the actual vehicle speed and the set speed is less than 4 mph (6.8 km/h), the set speed can be lowered 1 mph (1.6 km/h) each time by pressing the control lever downward in the "SET/COAST" direction quickly within 0.25 second. 700322 The cruise control indicator light comes on when the ignition switch is turned to the "ON" position and goes out after approximately three seconds. The light comes on when the "CRUISE" main switch is pressed. - CONTINUED -