2006 Subaru B9 Tribeca Owner's Manual - Page 315

Maintenance and service 11-19 Power steering fluid Checking the fluid level HOT MAX HOT MIN COLD MAX COLD MIN Be careful not to spill power steering fluid when adding it. If power steering fluid touches the exhaust pipe, it may cause a bad smell, smoke, and/or a fire. If power steering fluid gets on the exhaust pipe, be sure to wipe it off. The power steering fluid expands greatly as its temperature rises; the fluid level differs according to fluid temperature. Therefore, the reservoir tank has two different checking ranges for hot and cold fluids. Check the power steering fluid level monthly. 1. Park the vehicle on a level surface, and stop the engine. 2. Check the fluid level of the reservoir tank. When the fluid is hot after the vehicle has been run: Check that the oil level is between "HOT MIN" and "HOT MAX" on the surface of the reservoir tank. When the fluid is cool before the vehicle is run: Check that the oil level is between "COLD MIN" and "COLD MAX" on the surface of the reservoir tank. 3. If the fluid level is lower than the applicable "MIN" line, add the recommended fluid as necessary to bring the level between the "MIN" and "MAX" line. If the fluid level is extreme low, it may indicate possible leakage. Consult your SUBARU dealer for inspection. Recommended fluid "Dexron III" Type Automatic Transmission Fluid B00321 Be careful not to burn yourself because the fluid may be hot. When power steering fluid is being added, use only clean fluid, and be careful not to allow any dirt into the tank. And never use different brands together. Avoid spilling fluid when adding it in the tank.