2006 Subaru Forester Owner's Manual - Page 141
2006 Subaru Forester Manual
Page 141 highlights
3-28 Instruments and controls Compass zone adjustment 3 13 4 12 11 exit the zone setting mode. Remote control mirror switch Outside mirrors 1 2 5 6 7 8 9 10 300580 300581 Compass calibration zones 300146 1. The zone setting is factory preset to Zone 8. Refer to the "Compass calibration zone" map shown above or one attached to the end of this manual to verify that the compass zone setting is correct for your geographical location. 2. Press and hold the right button for 3 seconds then release, and the word "ZONE" will briefly appear and then the zone number will be displayed. 3. Press the right-hand button repeatedly to cycle the display through all possible zone settings. Stop cycling when the correct zone setting for your location is displayed. 4. Releasing the button for 3 seconds will 1) Selection switch 2) Direction control switch Convex mirror (passenger side) Objects look smaller in a convex mirror and farther away than when viewed in a flat mirror. Do not use the convex mirror to judge the distance of vehicles behind you when changing lanes. Use the inside mirror (or glance backwards) to determine the actual size and distance of objects that you view in convex mirror. The remote control mirrors operate only when the ignition switch is in the "ON" or "ACC" position. 1. Press either end of the selection switch, "L" for the left, "R" for the right. 2. Move the direction control switch in the direction you want to move the mirror. 3. Return the selection switch to the neutral position to prevent unintentional operation. The mirrors can also be adjusted manually.