2006 Subaru Forester Owner's Manual - Page 309
2006 Subaru Forester Manual
Page 309 highlights
11-36 Maintenance and service Replacement of wiper blades Grease, wax, insects, or other material on the windshield or the wiper blade results in jerky wiper operation and streaking on the glass. If you cannot remove the streaks after operating the windshield washer or if the wiper operation is jerky, clean the outer surface of the windshield (or rear window) and the wiper blades using a sponge or soft cloth with a neutral detergent or mild-abrasive cleaner. After cleaning, rinse the windshield and wiper blades with clean water. The windshield is clean if beads do not form when you rinse the windshield with water. 1 1 B00380 B00330 1) Stopper 1) Metal support 2. Remove the wiper blade assembly by holding its pivot area and pushing it in the direction shown by the arrow while depressing the wiper blade stopper. 3. Grasp the locked end of the blade rubber assembly and pull it firmly until the stoppers on the rubber are free of the metal support. Do not clean the wiper blades with gasoline or a solvent, such as paint thinner or benzene. This will cause deterioration of the wiper blades. If you cannot eliminate the streaking even after following this method, replace the wiper blades using the following procedures: Windshield wiper blades 1. Raise the wiper arm off the windshield.