2006 Subaru Legacy Owner's Manual - Page 129

3-14 Instruments and controls Warning and indicator lights Several of the warning and indicator lights come on momentarily and then go out when the ignition switch is initially turned to the "ON" position. This permits checking the operation of the bulbs. Apply the parking brake and turn the ignition switch to the "ON" position. The following lights come on: : Seatbelt warning light (The seatbelt warning light goes out only when the driver fastens the seatbelt.) : Front passenger's seatbelt warning light (The seatbelt warning light goes out only when the front seat passenger fastens the seatbelt.) : SRS airbag system warning light : CHECK ENGINE warning light / Malfunction indicator lamp : Charge warning light : Oil pressure warning light : AT OIL temperature warning light (AT vehicles) / : ABS warning light equipped) : Cruise control set indicator light (if equipped) If any lights fail to come on, it indicates a burned-out bulb or a malfunction of the corresponding system. Consult your authorized SUBARU dealer for repair. : Vehicle Dynamics Control operation indicator light (if equipped) : Vehicle Dynamics Control warning light (if equipped)/Vehicle Dynamics Control OFF indicator light (if equipped) / : Brake system warning light : AWD warning light (AT vehicles) : Low tire pressure warning light (if equipped) : SPORT mode indicator light (AT vehicles) / : Front passenger's frontal airbag ON indicator light / : Front passenger's frontal airbag OFF indicator light : Low fuel warning light : Door open warning light : Cruise control indicator light (if Seatbelt warning light and chime Your vehicle is equipped with a seatbelt warning device at the driver's and front passenger's seat, as required by current safety standards. With the ignition switch turned to the "ON" position, this device reminds the driver and front passenger to fasten their seatbelts by illuminating the warning lights in the locations indicated in the following illustration and sounding a chime.