2006 Subaru Legacy Owner's Manual - Page 141

3-26 Instruments and controls Information display (Vehicle without Navigation System) NOTE If your vehicle is equipped with a navigation system, refer to the separate "Operating Instructions for Monitor System". 300599 300600 To adjust the time shown by the clock, press the "+" button or the "-" button. The indicated time will change in one-minute increments. If you keep the button pressed, the rate at which the indicated time changes will speed up. To reset the minutes to "00" with a radio time signal, push the "SET" button. The clock will also show the time if you press the "DISP" button while the ignition switch is in the "LOCK" position. It is possible to adjust the time setting while the time is being shown. If you do not press the "+" button or "-" button for 10 seconds while the time is being shown, the time indication will go off. Also, the time indication will go off if you open and close the driver's door while the time is being shown. 300600 With the ignition switch in the "ON" position, each successive push of the "DISP" button toggles the display in the following sequence: To ensure safety, do not attempt to set the time during driving, as an accident could result.