2006 Subaru Legacy Owner's Manual - Page 204

Audio 5-31 low frequencies). Automatic tuning may not function properly if the station reception is weakened by distance from the station or proximity to tall buildings and hills. Selecting preset stations more than 1.5 seconds to store the frequency. If the button is pressed for less than 1.5 seconds, the preceding selection will remain in memory. NOTE 1 2 3 4 5 6 If the connection between the radio and battery is broken for any reason such as vehicle maintenance or radio removal, all stations stored in the preset buttons are cleared. If this occurs, it is necessary to reset the preset buttons. If a cell phone is placed near the radio, it may cause the radio to emit noise when it receives calls. This noise does not indicate a radio fault. matically play back. The player is designed to be able to play music CD-Rs and music CD-RWs, but it may not be able to play certain ones. Single CDs (i.e., 8 cm/3 inch CDs) are not supported, and if inserted, they will be immediately ejected. How to insert a CD(s) Inserting a CD 0 500233 Presetting a station with a "preset button" allows you to select that station in a single operation. Up to six AM, FM1 and FM2 stations each may be preset. How to preset stations 1. Press the "FM" or "AM" button to select FM1, FM2 or AM reception. 2. Press the " " or " " side of the button or tune the radio manually until the desired station frequency is displayed. 3. Press one of the preset buttons for Built-in CD changer operation NOTE Make sure to always insert a disc with the label side up. If a disc is inserted with the label side down, it might be ejected or the player might shut off. If a disc is inserted during a radio broadcast, the disc will interrupt the broadcast. After the last song finishes, the disc will automatically return to track 1 (the first song on the disc) and will auto- LOAD 500239 1. Briefly press the "LOAD" button. If the magazine in the player has an idle position where you can insert a disc, the disc number indicator associated with the idle position will blink. If no indicator blinks, it means that there is no idle position in the magazine. - CONTINUED -