2006 Subaru Outback Owner's Manual - Page 102
2006 Subaru Outback Manual
Page 102 highlights
Keys and doors 2-15 "AL on" and the horn sounds once, indicating that the system is now activated. 5. Close all doors (and the rear gate on the Station wagon). NOTE You may have the above setting change done by your SUBARU dealer. If you have accidentally triggered the alarm system To stop the alarm Do any of the following operations: Insert the key in the door lock of the driver's door and turn it to the unlock position. Press any button on the remote transmitter. Turn the ignition switch to the "ON" position. than two seconds). All doors (and the rear gate on the Station wagon) will lock, an electronic chirp will sound once, the turn signal lights will flash once, and the indicator lights will start flashing rapidly. After rapid flashing for 30 seconds (standby time), the indicator lights will then flash slowly (twice approximately every two seconds), indicating that the system has been armed for surveillance. If any of the doors, (rear gate or trunk lid) is not fully closed, an electronic chirp sounds five times, the turn signal lights flash five times to alert you that the doors (or the rear gate) are not properly closed. When you close the door, the system will automatically arm and doors will automatically lock. To arm the system using power door locking switches 1. Close all windows. 2. Remove the key from the ignition switch. 3. Open the doors and get out of the vehicle. 4. Make sure that the engine hood is locked. 5. Close the doors (and the rear gate on the station wagon) but leave only the driver's door or the front passenger's door open. - CONTINUED - 200918 : Press to Arm the system. : Press to Disarm the system. Arming the system To arm the system using remote transmitter 1. Close all windows and the moonroof (if so equipped). 2. Remove the key from the ignition switch. 3. Open the doors and get out of the vehicle. 4. Make sure that the engine hood (and the trunk lid on the Sedan) are locked. 200835 6. Briefly press the " " button (for less