2006 Subaru Outback Owner's Manual - Page 140
2006 Subaru Outback Manual
Page 140 highlights
Instruments and controls 3-25 possible. Refer to the "Replacing bulbs" section in chapter 11. Cruise control set indicator light The cruise control set indicator light comes on when the ignition switch is turned to the "ON" position and goes out after approximately three seconds. This light comes on when vehicle speed has been set. Clock NOTE If your vehicle is equipped with a navigation system, refer to the separate "Operating Instructions for Monitor System". High beam indicator light This light shows that the headlights are in the high beam mode. This indicator light also comes on when the headlight flasher is operated. Cruise control indicator light The cruise control indicator light comes on when the ignition switch is turned to the "ON" position and goes out after approximately three seconds. This light comes on when the "CRUISE" main switch is pressed. Headlight indicator light This indicator light comes on when the light switch is turned to the " " position (to turn on the parking lights) or to the " " position (to turn on the headlights). Front fog light indicator light This indicator light is on while the front fog lights are on. 400257 NOTE If you move the cruise control lever or press the main switch button while turning the ignition switch "ON", the cruise control function is deactivated and the "CRUISE" indicator light flashes. To reactivate the cruise control function, turn the ignition switch back to the "ACC" or "LOCK" position, and then turn it again to the "ON" position. The clock shows the time while the ignition switch is in the "ACC" or "ON" position. - CONTINUED -