2006 Subaru Outback Owner's Manual - Page 190

Audio 5-17 Tuning Manual tuning NOTE Automatic tuning (SCAN) While you are holding down either side of the TUNE/TRACK button, the tuning frequency will not stop changing even if the frequency of a receivable station is reached. Seek tuning TUNE TRACK SEEK SCAN 500049 SEEK SCAN 500232 Push the " " side of the TUNE/TRACK button to increase the tuning frequency and press the " " side of the button to decrease it. Each time the button is pressed, the frequency interval can be changed between 10 KHz in the AM mode and 0.2 MHz in the FM mode. If you hold down the " " side of the button, the tuning frequency will increase continuously, and if you hold down the " " side of the button, the tuning frequency will decrease continuously. Release the button when your desired frequency is reached. 500232 If you press the " " or " " side of the SEEK/SCAN button and release it within 1.5 second, the radio will automatically search for a receivable station and stop at the first one it finds. This function may not be available, however, when radio signals are weak. In such a situation, perform manual tuning to select the desired station. If you press the " " or " " side of the SEEK/SCAN button for 1.5 second or longer, the radio will switch to scan mode. In this mode, the radio scans through the radio band until a station is found. The radio will stop at the station for five seconds while displaying the frequency, after which scanning will continue until the entire band has been scanned from the low end to the high end. Press the " " or " " side of the button again to cancel the scan mode and to stop on any displayed frequency. If you hold down the " " side of the button, the radio will scan up the frequency band (from low frequencies to high frequencies). If you hold down the " " side of the button, the radio will scan down the - CONTINUED -