2006 Subaru Outback Owner's Manual - Page 237
2006 Subaru Outback Manual
Page 237 highlights
6-20 Interior equipment trol System and your garage door opener should activate when the HomeLink® button is pressed. ory of all three buttons. 3. Hold the end of the entrance gate's/garage door opener's hand-held transmitter between 1 and 3 inches (25 and 76 mm) away from the HomeLink® buttons on the driver's sun visor, keeping the indicator light in view. opener by pressing the programmed HomeLink® button. Programming for entrance gates and garage door openers in Canada 1. Unplug the motor of the entrance gate or garage door opener from the outlet. Programming other devices To program other devices such as door locks, home lighting and security systems, contact HomeLink at www.homelink.com or call 1-800-355-3515. Operating the HomeLink® Wireless Control System Once programmed, the HomeLink® Wireless Control System can be used to remote-control the devices to which its buttons are programmed. To activate a device, simply press the appropriate button. The indicator light illuminates, indicating that the signal is being transmitted. 600434 600430 2. Press and hold the two outside buttons until the HomeLink® indicator light begins to flash (after 20 seconds). Release both buttons. NOTE If any of the HomeLink® buttons are already programmed for other devices, skip step 2 because it clears the mem- 4. Press and hold the desired HomeLink® button. 5. Press and release ("cycle") the handheld transmitter button every two seconds until step 6 is complete. 6. When the indicator light flashes slowly and then rapidly after several seconds, release both buttons. 7. Plug the motor of the entrance gate/garage door opener to the outlet. 8. Test your entrance gate/garage door Reprogramming a single HomeLink® button 1. Press and hold the HomeLink® button you wish to reprogram. DO NOT release the button until step 4 has been completed. 2. When the HomeLink® indicator light begins to flash slowly (after 20 seconds), position the hand-held transmitter of the device for which you wish to program the button at 1 to 3 inches (25 to 76 mm) away