2006 Subaru Outback Owner's Manual - Page 385

11-52 Maintenance and service gap A between the side cover and rear combination lamp and use it as a lever to undo the clip. Undo clips C and D in the same way, then remove the side cover. 3 1 Backup light (Station wagon) 2 B00439 B00136 1) Brake/tail light 2) Rear turn signal light 3) Rear side marker light B00138 3. Remove the upper and lower screws. Then, slide the rear combination lamp assembly to the rear and remove it from the vehicle. 4. Remove the bulb holder from the rear combination light assembly by turning it counterclockwise. 5. Pull the bulb out of the bulb holder and replace it with a new one. 6. Set the bulb holder into the rear combination light assembly and turn it clockwise until it locks. 7. Close the cover and latch the lock. 8. Reinstall the rear combination light assembly and its side cover. 1. Use a flat-head screwdriver to remove the light cover from the top of the left-hand rear gate trim. B00139 2. Turn the bulb socket counterclockwise