2008 Subaru Outback Owner's Manual - Page 135

3-16 Instruments and controls To change the current setting, take the following steps. 1. Within 12 seconds after turning on the ignition switch, press the " /SET" switch for at least 2 seconds. 2. T h e d i s p l a y s h o w s " M E T E R SETTING", and then changes to the setting screen. 3. When the setting screen is displayed, select "Initial movement" by pressing the " " or " " switch. And press the " / SET" switch to enter the setting process. 4. Select "ON" for activated initial movement or "OFF" for deactivated initial movement by pressing the " " or " " switch. And press the " /SET" switch to decide the desired setting. If you do not need to change the previous setting, select " " and press the " /SET" switch. 5. Select "End" by pressing the " " or " " switch. And press the " /SET" switch to finish the meter setting menu. NOTE . Your vehicle's initial movement setting of the meter/gauge needles has been set for activation "ON" at the time of shipment from the factory. . If you turn the ignition switch to the "Acc" position, turn the ignition switch to the "LOCK" position, or open and close the driver's door during the setting procedure, the new setting will be canceled. . It is not possible to cancel sequential illumination of the combination meter while sequential illumination is actually taking place. Cancel sequen-