2008 Subaru Outback Owner's Manual - Page 155
2008 Subaru Outback Manual
Page 155 highlights
3-36 NOTE Instruments and controls This light does not go out unless the tank is replenished up to an internal fuel quantity of approximately 3.7 US gal (14 liters, 3.1 Imp gal). & All-Wheel Drive warning light (AT models) WARNING Continued driving with the AWD warning light flashing can lead to powertrain damage. If the AWD warning light flashes, promptly park in a safe place then check whether all four tires are the same diameter and whether any of the tires has a puncture or has lost air pressure for some other reason. The All-Wheel Drive warning light comes on when the ignition switch is turned to the "ON" position and goes out after the engine has started. ! For 5-speed automatic transmission vehicles This light flashes if the vehicle is driven with tires of different diameters fitted on its wheels or with the air pressure excessively low in any of its tires. ! For 4-speed automatic transmission vehicles This light comes on when All-Wheel Drive is disengaged and the drive mechanism is switched to Front Wheel Drive for main- tenance or similar purposes. This light flashes if the vehicle is driven with tires of different diameters fitted on its wheels or with the air pressure excessively low in any of its tires. CAUTION Promptly put fuel in the tank whenever the low fuel warning light comes on. Engine misfires as a result of an empty tank could cause damage to the engine. & Vehicle Dynamics Control operation indicator light (if equipped) & Door open warning light When any of the doors, the rear gate (Station wagon) or the trunk lid (Sedan) is not fully closed, the door open warning light comes on. For a vehicle without SI-DRIVE, the open door is indicated by the corresponding part of the door open warning light. For a vehicle with SI-DRIVE, the opening door is indicated on the multi-information display. Always make sure this light is out before you start to drive. This light comes on when the ignition switch is ON and goes out approximately 2 seconds later. It blinks when the skid suppression function is activated. It illuminates when only the traction control function is operating. The Vehicle Dynamics Control system is probably faulty under any of the following conditions. Have your vehicle checked at a SUBARU dealer immediately. . The light does not come on when the ignition switch is turned to the "ON" position. . The light does not go out even after a period of approximately 2 seconds after the ignition switch has been turned to the "ON" position.
![](/manual_guide/autos/2008-subaru-outback-owners-manual-732ab7d/155.png)