2008 Subaru Outback Owner's Manual - Page 240

6-20 Interior equipment trol System and your garage door opener should activate when the HomeLink® button is pressed. memory of all three buttons. 3. Hold the end of the entrance gate's/ garage door opener's hand-held transmitter between 1 and 3 inches (25 and 76 mm) away from the HomeLink® buttons on the driver's sun visor, keeping the indicator light in view. & Programming for entrance gates and garage door openers in Canada 1. Unplug the motor of the entrance gate or garage door opener from the outlet. 1) Training button 2. Press the training button on the garage door opener motor head unit (which activates the "training light" on the unit). Proceed to step 3 within 30 seconds. 3. Inside the vehicle, firmly press and release the HomeLink® button that was programmed in the section above. Press and release the button a second time to complete the programming procedure. NOTE Some garage door openers may require you to do the above procedure a third time to complete the programming. 4. The garage door opener should now recognize the HomeLink® Wireless Con- 2. Press and hold the two outside buttons until the HomeLink® indicator light begins to flash (after 20 seconds). Release both buttons. NOTE If any of the HomeLink® buttons are already programmed for other devices, skip step 2 because it clears the 4. P r e s s a n d h o l d t h e d e s i r e d HomeLink® button. 5. Press and release ("cycle") the handheld transmitter button every 2 seconds until step 6 is complete. 6. When the indicator light flashes slowly and then rapidly after several seconds, release both buttons. 7. Plug the motor of the entrance gate/ garage door opener to the outlet. 8. Test your entrance gate/garage door