2008 Subaru Outback Owner's Manual - Page 400

11-54 Maintenance and service ! High beam light bulbs 2. Use a screwdriver to remove the secured clip of the washer tank. To make it easy to access the bulb, move the washer tank to the horizontal direction. (left-hand side) place and secure it by clip. (left-hand side) & Front turn signal light and parking light It may be difficult to replace the bulbs. Have the bulbs replaced by your SUBARU dealer if necessary. & Front fog light (if equipped) It may be difficult to replace the bulbs. Have the bulbs replaced by your SUBARU dealer if necessary. Right-hand side 1. Use a screwdriver to undo the clips on the air intake duct, then remove the air intake duct. (right-hand side) Left-hand side 3. Disconnect the electrical connector from the bulb. 4. Remove the bulb from the headlight assembly by turning it counterclockwise. 5. Replace the bulb with new one. At this time, use care not to touch the bulb surface. 6. Reconnect the electrical connector. 7. To install the bulb to the headlight assembly, turn it clockwise until it clicks. 8. Install the air intake duct with clips. (right-hand side) 9. Set the washer tank to the original