2008 Subaru Outback Owner's Manual - Page 402

11-56 Maintenance and service 3) Rear side marker light 4. Remove the bulb holder from the rear combination light assembly by turning it counterclockwise. 5. Pull the bulb out of the bulb holder and replace it with a new one. 6. Set the bulb holder into the rear combination light assembly and turn it clockwise until it locks. 2. Wrap tape around a flat-head screwdriver, then insert the screwdriver into the gap between the side cover and rear combination lamp and use it as a lever to undo clip 1 in the illustration shown. Undo clips 2 and 3 in the same way, then remove the side cover. 3. Remove the upper and lower screws. Then, straightly slide the rear combination lamp assembly rearward and remove it from the vehicle. 7. Insert the harness into the holder. 1) 2) Brake/tail light Rear turn signal light