2008 Subaru Outback Owner's Manual - Page 62
2008 Subaru Outback Manual
Page 62 highlights
Seat, seatbelt and SRS airbags 1-37 facturer, connect the lower hooks onto the lower anchorages located at " " marks on the bottom of the rear seatback. When the hooks are connected, make sure the adjacent seatbelts are not caught. instructions by the child restraint system manufacturer. Since a top tether can provide additional stability by offering another connection between a child restraint system and the vehicle, we recommend that you use a top tether whenever one is required or available. ! Tether anchorage location ! Sedan 4. Before seating a child in the child restraint system, try to move seat back and forth and left and right to verify that it is held securely in position. 5. To remove the child restraint system, follow the reverse procedures of installation. If you have any question concerning this type of child restraint system, ask your SUBARU dealer. 2. If your child restraint system is of a flexible attachment type (which uses tether belts to connect the child restraint system properly to the lower anchorages), while pushing the child restraint into the seat cushion, pull both left and right lower tether belts up to secure the child restraint system firmly by taking up the slack in the belt. 3. Connect the top tether hook to the tether anchorage and firmly tighten the tether. For information on how to set the top tether, read the following "Top tether anchorages". & Top tether anchorages Your vehicle is equipped with three top tether anchorages so that a child restraint system having a top tether can be installed in the rear seat. When installing a child restraint system using top tether, proceed as follows, while observing the Three tether anchorages are installed on the rear shelf behind the rear seat head restraint. Open the cover flap to use each anchorage. - CONTINUED -