2009 Subaru Forester Owner's Manual - Page 53

1-28 Seat, seatbelt and SRS airbags 9. To remove the child restraint system, press the release button on the seatbelt buckle and allow the belt to retract completely. The belt will return to the ELR mode. injuries or death to the child. CAUTION When you install a child restraint system, follow the manufacturer's instructions supplied with it. After installing the child restraint system, check to ensure that it is held securely in position. If it is not held tight and secure, the danger of your child suffering personal injury in the event of an accident may be increased. NOTE When the child restraint system is no longer in use, remove it and restore the ELR function of the retractor. That function is restored by allowing the seatbelt to retract fully. 8. If the child restraint system requires a top tether, latch the hook onto the top tether anchorage and tighten the top tether. Refer to "Top tether anchorages" in this section for additional instructions. & Installing a booster seat WARNING . Child restraint systems and seatbelts can become hot in a vehicle that has been closed up in sunny weather; they could burn a small child. Check the child restraint system before you place a child in it. . Do not leave an unsecured child restraint system in your vehicle. Unsecured child restraint systems can be thrown around inside of the vehicle in a sudden stop, turn or accident; they can strike and injure vehicle occupants as well as result in serious 1. Place the booster seat in the rear seating position and sit the child on it. The child should sit well back on the booster