2009 Subaru Forester Owner's Manual - Page 97

2-10 Keys and doors the audible signal off. Do the following to deactivate the audible signal. You can also use the same steps to restore the function. 1. Sit in the driver's seat and shut all doors and the rear gate. 2. Hold down the UNLOCK side of the power door locking switch. 3. While holding down the "UNLOCK" side of the power door locking switch, pull the key out and re-insert it into the ignition switch at least 6 times within 10 seconds after Step 2. 4. Open and close the driver's door once within 10 seconds after Step 3. 5. The turn signal lights flash 3 times to indicate completion of the setting. You may have the above settings done by your SUBARU dealer. as possible. To replace the battery: 1) Negative (−) side facing up 1. Open the transmitter case using a flathead screwdriver. 3. Replace with a new battery (type CR2025 or equivalent) making sure to install the new battery with the negative (−) side facing up. 4. Refit the removed half of the transmitter case. After the battery is replaced, the transmitter must be synchronized with the keyless entry system's control unit. Press either the " " or " " button six times to synchronize the unit. & Replacing the battery CAUTION Do not let dust, oil or water get on or in the transmitter when replacing the battery. When the transmitter battery begins to get weak, transmitter range will begin to decrease. Replace the battery as soon & Replacing lost transmitters If you lose a transmitter or want to purchase additional transmitters (up to four can be programmed), you should reprogram all of your transmitters for secur- 2. Remove the old battery from the holder.