2011 Subaru Forester Owner's Manual - Page 102
2011 Subaru Forester Manual
Page 102 highlights
Keys and doors 2-17 cally locked. ! To arm the system using power door locking switches 1. Close all windows. 2. Remove the key from the ignition switch. 3. Open the doors and get out of the vehicle. 4. Make sure that the engine hood is locked. 5. Close the doors and the rear gate but leave only the driver's door or the front passenger's door open. once and the indicator lights will start flashing rapidly. After rapid flashing for 30 seconds (standby time), the indicator lights will then flash slowly (twice approximately every 2 seconds), indicating that the system has been armed for surveillance. - Ignition switch is turned to the "ON" position. & Disarming the system Briefly press the " " button (for less than 2 seconds) on the remote transmitter. The driver's door will unlock, an electronic chirp will sound twice, the turn signal lights will flash twice. The flashing of the security indicator light will then change slowly (once approximately every 3 seconds from twice approximately every 2 seconds), indicating that the alarm system has been disarmed. NOTE . The system can be armed even if the engine hood, the windows and/or moonroof (if equipped) are open. Always make sure that they are fully closed before arming the system. . The 30-second standby time can be eliminated if you prefer. Have it performed by your SUBARU dealer. . The system is in the standby mode for a 30-second period after locking the doors with the remote transmitter. The security indicator light will flash at short intervals during this period. . If any of the following actions are done during the standby period, the system will not switch to the surveillance state. - Doors are unlocked using the remote transmitter. - Any door (including the rear gate) is opened. NOTE After disarming the alarm system, briefly press the " " button a second time within 5 seconds to unlock all other doors and the rear gate. ! Emergency disarming If you cannot disarm the system using the transmitter (i.e. the transmitter is lost, broken or the transmitter battery is too weak), you can disarm the system without using the transmitter as follows. . Turn the ignition switch from the "LOCK" to the "ON" position with a registered key. 6. Push the front side ("LOCK" side) of the power door locking switch to set the door locks. 7. Close the door. An electronic chirp will sound once, the turn signal lights will flash - CONTINUED -