2011 Subaru Forester Owner's Manual - Page 220

Audio 5-41 & MUTE button (models without Hands-free system) Bluetooth® audio (type C and D audio) This function enables you to play back audio sources from Bluetooth® audio devices. You need to register the Bluetooth® audio device in the system before using it. NOTE You cannot set a Bluetooth® audio while driving. ! Registering (pairing) device 1. Select the "PAIR AUDIO" (type C audio)/"Pair Audio Player" (type D audio) menu. If a device is already registered, "MEMORY FULL" is displayed and the mode changes to the Bluetooth® audio setting mode. 2. After the passkey is shown on the display, input the passkey into the cell phone. If you input the correct passkey, "PAIRED" is displayed and the registering procedure is finished. If you input an incorrect passkey, "FAILED" is displayed, the registering procedure was not successful and the mode changes to the Bluetooth® audio setting mode. & Media format Bluetooth® audio devices cannot be connected if they are not compatible with the following Bluetooth® profiles. . A2DP (Advanced Audio Distribution Profile) . AVRCP (Audio/Video Remote Control Profile) Press the " " button if you wish to immediately cut the volume to zero. The audio display will show "MUTE". If you press the button again, the original sound volume will return and "MUTE" turns off. & Setting Bluetooth® audio 1. Select "BT-A SETUP" by pressing the "MENU" button (type C audio)/Select "BT Audio Setup" by operating the "TUNE/ TRACK/CH" dial (type D audio). 2. Perform the following procedure by operating the "TUNE/TRACK/CH" dial while "BT-A" (type C audio)/"BT Audio" (type D audio) is displayed. NOTE After the ignition switch is turned to the "LOCK" position, the registered device is not automatically connected to the system even if the ignition switch is turned to the "Acc" or "ON" position. ! Selecting device 1. Select the "SELECT AUDIO" (type C audio)/"Select Audio Player" (type D - CONTINUED -