2011 Subaru Forester Owner's Manual - Page 95

2-10 Keys and doors & Sounding a panic alarm non-operational setting can be changed. Models with genuine SUBARU navigation system: The setting can be changed using the navigation monitor. For details, refer to the Owner's Manual Supplement for the navigation system. Models without genuine SUBARU navigation system: The setting can be changed by your SUBARU dealer. Contact your SUBARU dealer for details. 4. Open and close the driver's door once within 10 seconds after step 3. 5. The turn signal lights flash 3 times to indicate completion of the setting. You may have the above settings done by your SUBARU dealer. Contact your SUBARU dealer for details. For models with a genuine SUBARU navigation system, the settings can be changed using the navigation monitor. For details, refer to the Owner's Manual Supplement for the navigation system. A "PANIC" button is located on the back of the transmitter. To activate the alarm, press the "PANIC" button once. The horn will sound and the turn signal lights will flash. To deactivate the panic alarm, press any button on the remote transmitter. Unless a button on the remote is pressed, the alarm will be deactivated after approximately 30 seconds. & Selecting audible signal operation Using an electronic chirp, the system will give you an audible signal when the doors lock and unlock. If desired, you may turn the audible signal off. Do the following to deactivate the audible signal. You can also use the same steps to restore the function. 1. Sit in the driver's seat and shut all doors and the rear gate. 2. Hold down the UNLOCK side of the power door locking switch. 3. While holding down the "UNLOCK" side of the power door locking switch, pull the key out and re-insert it into the ignition switch at least 6 times within 10 seconds after step 2. & Replacing the battery CAUTION . Do not let dust, oil or water get on or in the transmitter when replacing the battery. . Be careful not to damage the printed circuit board in the transmitter when replacing the battery. . Be careful not to allow children to touch the battery and any removed parts; children could swallow them. . There is a danger of explosion if an incorrect replacement battery is used. Replace only with the same or equivalent type of bat- & Selecting turn signal lights operation When the remote keyless entry system is used, the turn signal lights flash. However, the turn signal lights flashing operational/