2007 Suzuki Reno Owner's Manual - Page 35
2007 Suzuki Reno Manual
Page 35 highlights
SEATS AND RESTRAINT SYSTEMS Securing a Child Restraint Designed for the LATCH System (Rear) 1) Find the anchors for the seating position you want to use, where the bottom of the seatback meets the back of the seat cushion. 2) Put the child restraint on the seat. 3) Attach the anchor points on the child restraint to the anchors in the vehicle. The child restraint instructions will show you how. 4) If the child restraint is forward-facing, attach the top strap to the top strap anchor. See "Top Strap" in this section. Tighten the top strap according to the child restraint instructions. 5) Push and pull the child restraint in different directions to be sure it is secure. To remove the child restraint, simply unhook the top strap from the top tether anchor and then disconnect the lower anchor points. L3U1047A A C B L3U1050A B A With this type of child restraint, use the LATCH system instead of the vehicle's safety belts to secure the child restraint. WARNING L3U1049A In order to use the system, you need either a forward-facing child restraint that has attaching points (B) at its base and a top tether anchor (C), or a rear-facing child restraint that has attaching points (B), as shown here. If a LATCH-type child restraint isn't attached to its anchorage points, the restraint won't be able to protect the child correctly. In a crash, the child could be severely injured or killed. Make sure that a LATCH-type child restraint is properly installed using the anchorage points. If your child restraint is not designed for the LATCH system, use the vehicle's safety belts to secure the restraint, following the instructions that came with that restraint, and also the instructions in this manual. 1-23