2007 Suzuki XL7 Owner's Manual - Page 88
2007 Suzuki XL7 Manual
Page 88 highlights
INSTRUMENT PANEL the vehicle's speed for approximately 60 seconds, cruise control will disengage. Using Cruise Control on Hills How well your cruise control will work on hills depends upon your speed, load, and the steepness of the hills. When going up steep hills, you may have to step on the accelerator pedal to maintain your vehicle's speed. When going downhill, you may have to brake or shift to a lower gear to limit the vehicle's speed. Of course, applying the brakes ends cruise control. Many drivers find this to be too much trouble and do not use cruise control on steep hills. Ending Cruise Control There are three ways to end cruise control: • Step lightly on the brake pedal. • Press the cancel button on the steering wheel. • Press the On/Off button on the steering wheel. Erasing Speed Memory When the cruise control or the ignition is turned off, the cruise control set speed memory is erased. Headlamps The exterior lamp control is located on the turn signal/multifunction lever. (Exterior Lamp Control): Turn the control with this symbol on it to operate the exterior lamps. The exterior lamp control has the following positions: AUTO (Off/Automatic Headlamps): Turn the control to this position to put the headlamps in automatic mode. Automatic mode will turn the exterior lamps on and off depending upon how much light is available outside of the vehicle. (Parking Lamps): Turn the control to this position to turn on the parking lamps together with the following Sidemarker Lamps Taillamps License Plate Lamps Instrument Panel Lights Daytime Running Lamps (DRL) Daytime Running Lamps (DRL) can make it easier for others to see the front of your vehicle during the day. DRL can be helpful in many different driving conditions, but they can be especially helpful in the short periods after dawn and before sunset. Fully functional daytime running lamps are required on all vehicles first sold in Canada. A light sensor on top of the instrument panel makes the DRL work, so be sure it is not covered. The DRL system's automatic headlamp control will make the low-beam headlamps come on at a reduced brightness when the following conditions are met: • The ignition is in RUN. • The exterior lamps control is in AUTO. • The engine is running. When the DRL are on, only the low-beam headlamps, at a reduced level of brightness, will be on. The headlamps, taillamps, sidemarker, and other lamps will not be on. The instrument panel and cluster will also not be lit. When it is dark enough outside, the DRL will turn off and the headlamps and parking lamps will turn on. The other lamps that come on with the headlamps will also come on. (Headlamps): Turning the control to this position turns on the headlamps, together with the previously listed lamps and lights. Headlamps on Reminder If you open the driver's door with the ignition off and the lamps on, you will hear a warning chime. 3-7