2008 Suzuki Forenza Owner's Manual - Page 81

INSTRUMENT PANEL As you signal a turn or a lane change, if the arrows flash rapidly, a signal bulb may be burned out and other drivers won't see your turn signal. If a bulb is burned out, replace it to help avoid an accident. If the arrows don't go on at all when you signal a turn, check for burned-out bulbs and then check the fuse. See "Fuses and Circuit Breakers" in section 5. Headlamp High/Low-Beam Changer Windshield Wiper/Washer Lever The windshield wiper/washer lever is located on the right side of the steering wheel. Windshield Wiper When the high beams are on, a light on the instrument panel cluster also will be on if the ignition is ON. To change the headlamps from high beam to low beam, pull the turn signal/multifunction lever toward you. Flash-to-Pass Feature This feature lets you use your high-beam headlamps to signal a driver in front of you that you want to pass. To use it, pull the turn signal/multifunction lever toward you until the high-beam headlamps come on, then release the lever to turn them off. Use the windshield wiper/washer lever to operate the windshield wipers. HI (High Speed): Move the lever to this position for wiping at high speed. LO (Low Speed): Move the lever to this position for steady wiping at low speed. INT (Intermittent): Move the lever to this position to choose a delayed wiping cycle. Turn the band on the windshield wiper lever toward FAST or SLOW for a shorter or longer delay N6U3003A To change the headlamps from low beam to high beam, push the turn signal multifunction lever away from you. 3-5