2008 Suzuki XL7 Owner's Manual - Page 111
2008 Suzuki XL7 Manual
Page 111 highlights
INSTRUMENT PANEL This message cannot be acknowledged. THEFT ATTEMPTED This message displays if the content theftdeterrent system has detected a break-in attempt while you were away from your vehicle. Refer to "Content Theft-Deterrent" in "Theft-Deterrent Systems" in the "Features and Controls" section for more information. TIRE LEARNING ACTIVE This message displays when the Tire Pressure Monitor System (TPMS) is relearning the tire positions on your vehicle. Refer to "Tire Pressure Monitor System" in "Tires" in the "Service and Appearance Care" section. The tire positions must be re-learned after rotating the tires or after replacing a tire or sensor. Refer to "Tire Inspection and Rotation", "Tire Pressure Monitor System" in "Tires" in the "Service and Appearance Care" section and "Inflation - Tire Pressure" in "Tires" in the "Service and Appearance Care" section for more information. TRACTION CONTROL OFF This message displays when the Traction Control System (TCS) turns off. Refer to "Traction Control System (TCS)" in "Your Driving, the Road, and Your Vehicle" in the "Driving Your Vehicle" section for more information. This message only displays while the ignition is in ON/RUN and disappears after 10 seconds, unless it is acknowledged or an urgent warning appears. Any of the following conditions may cause the TCS to turn off: • The TCS is turned off by pressing the traction control button. Refer to "Traction Control System (TCS)" in "Your Driving, the Road, and Your Vehicle" in the "Driving Your Vehicle" section for more information. • The battery is low. • There is a TCS failure. See your dealer for service. TRACTION CONTROL ON This message displays when the Traction Control System (TCS) turns on. Refer to "Traction Control System (TCS)" in "Your Driving, the Road, and Your Vehicle" in the "Driving Your Vehicle" section for more information. TURN SIGNAL ON This message displays as a reminder to turn off the turn signal if you drive your vehicle for more than about 0.75 mile (1.2 km) with a turn signal on. Refer to "Turn Signal/Multifunction Lever" in this section. This message displays and a chime sounds only when the ignition is in ON/ RUN. The message will not disappear until the turn signal is manually turned off, or a turn is completed. DIC Vehicle Personalization Your vehicle has personalization capabilities that allow you to program certain features to one preferred setting. All of the personalization options may not be available on your vehicle. Only the options available will be displayed on the DIC. The default settings for the personalization features were set when your vehicle left the factory, but may have been changed from their default state since then. The personalization preferences are automatically recalled. To change personalization preferences, use the following procedure. Entering the Feature Settings Menu 1) Turn the ignition on and place the vehicle in PARK (P). To avoid excessive drain on the battery, it is recommended that the headlamps are turned off. 2) Press the vehicle information button until FEATURE SETTNGS (Settings): PRESS TO SELCT (Select) appears on the DIC display. 3) Press the set/reset button to enter the feature settings menu. If the menu is not available, FEATURE SETTNGS (Settings): AVAILABLE IN PRK (Park) will display. Before entering the menu, make sure the vehicle is in PARK (P). 3-34