2008 Suzuki XL7 Owner's Manual - Page 116
2008 Suzuki XL7 Manual
Page 116 highlights
INSTRUMENT PANEL Setting the Time CAUTION Before adding any sound equipment to your vehicle, such as an audio system, CD player, CB radio, mobile telephone, or two-way radio, make sure that it can be added by checking with your dealer. Also, check federal rules covering mobile radio and telephone units. If sound equipment can be added, it is very important to do it properly. Added sound equipment may interfere with the operation of your vehicle's engine, radio, or other systems, and even damage them. Your vehicle's systems may interfere with the operation of sound equipment that has been added. Your vehicle has a feature called Retained Accessory Power (RAP). With RAP, the audio system can be played even after the ignition is turned off. Refer to "Retained Accessory Power (RAP)" in "Starting and Operating Your Vehicle" in the "Features and Controls" section for more information. Without Date Display AM/FM Base Radio with a Single CD Player This type of radio has a (clock) button for setting the time. Set the time by following these steps: 1) Turn the radio on. 2) Press the button until the hour begins flashing on the display. Press the button a second time and the minutes begin flashing on the display. 3) While either the hour or the minutes are flashing, turn the (tune) knob, located on the upper right side of the radio, clockwise or counterclockwise to increase or decrease the time. Instead of using the knob, you can also press the left or right SEEK arrow, FWD (forward), or REV (reverse) buttons to adjust the time. 4) Press the button again until the clock display stops flashing to set the currently displayed time; otherwise, the flashing stops after five seconds and the current time displayed is automatically set. With Date Display Single CD (MP3) or a Single CD and DVD (MP3) Player These radios have a (clock) button for setting the time and date. To set the time and date, follow these instructions: 1) Turn the radio on. 2) Press the button and the HR, MIN, MM, DD, YYYY (hour, minute, month, day, and year) displays. 3) Press the pushbutton located under any one of the labels that you want to change. Every time the pushbutton is pressed again, the time or the date if selected, increases by one. - Another way to increase the time or date, is to press the right SEEK arrow or FWD (forward) button. - To decrease, press the left SEEK arrow or REV (reverse) button. You can also turn the (tune) knob, located on the upper right side of the radio, to adjust the selected setting. The date does not automatically display. To see the date press the button while the radio is on. The date with display times out after a few seconds and goes back to the normal radio and time display. To change the time default setting from 12 hour to 24 hour, press the button and then the pushbutton located under the forward arrow label. Once the time 12H and 24H are displayed, press the pushbutton located under the desired option to select the default. Press the button again to apply the selected default, or let the screen time out. 3-39