2008 Suzuki XL7 Owner's Manual - Page 88
2008 Suzuki XL7 Manual
Page 88 highlights
INSTRUMENT PANEL Automatic Climate Control System with Rear Air Conditioning and Heating System the system to heat or cool any faster. In cold weather; the system starts at lower fan speeds to avoid blowing cold air into the vehicle until warmer air is available. The system begins blowing air at the floor, but can change modes automatically as the vehicle warms up to maintain the chosen temperature setting. The length of time needed to warm the interior depends on the outside temperature and temperature of the vehicle. 3) Wait 20 to 30 minutes for the system to stabilize in order for the system to regulate automatically. Then adjust the temperature as necessary to find your comfort setting. Do not cover the solar sensor located in the center of the instrument panel near the windshield. For more information on the solar sensor, refer to "Sensors" later in this section. (AUTO RECIRCULATION): Using the previous temperature setting, the system automatically controls the air inlet to supply fresh outside air or recirculate the interior air to cool the car faster. The indicator light on the recirculation button lights whenever the system switches to recirculation. Switch to outside air by pressing the Outside Air button or by pressing the recirculation button, if the vehicle has a rear climate control system. See AUX for more information. The next time AUTO fan or AUTO mode is selected, the air inlet resets back to AUTO operation. Manual Operation (Fan): Turn the left knob to increase or decrease the fan speed. In any setting other than off, the fan runs continuously with the ignition on. To turn off the air completely, turn the fan to 0 and select the recirculation button. Temperature Control: Turn the center knob to increase or decrease the temperature inside your vehicle. Use the right knob to select from the following modes: There is one position between each mode to finely adjust airflow position. (Vent): This mode directs air to the instrument panel outlets. (Bi-Level): This mode spilits the air between the instrument panel outlets and the floor outlets. (Floor): This mode directs most of the air to the floor outlets with some air directed to the windshield and side window outlets. 1732674 Automatic Operation AUTO (Automatic Fan): When this position is selected on the fan control, the system automatically adjusts the fan speed. Temperature Setting: The system uses the outside temperature, passenger compartment air temperature, and solar load sensors to maintain the chosen temperature setting. AUTO (Automatic Mode): 1) Turn the mode control to the AUTO position. 2) Adjust the temperature to a comfortable setting between 31°F (16°C) and 89°F (31°C). Choosing the coldest or warmest temperature setting does not cause 3-11