2009 Suzuki SX4 Owner's Manual - Page 205

Engine Coolant: 1, 2 INSPECTION AND MAINTENANCE Refill with Oil and Check for Leaks 1) Pour oil through the filler hole and install the filler cap. For the approximate capacity of the oil, refer to the "Capacities" item in the "SPECIFICATIONS" section. 2) Start the engine and look carefully for leaks at the oil filter and drain plug. Run the engine at various speeds for at least 5 minutes. 3) Stop the engine and wait about 5 minutes. Check the oil level again and add oil if necessary. Check for leaks again. EXAMPLE Gear Oil Specified Gear Oil Manual transaxle (API GL-4) 54G095 CAUTION When replacing the oil filter, it is recommended that you use a genuine SUZUKI replacement filter. If you use an after-market filter, make sure it is of equivalent quality and carefully follow the manufacturer's instructions and precautions. 80J014 Rear differential oil (i-AWD)/Transfer oil of automatic transaxle model (i-AWD) (API GL-5 Hypoid) CAUTION Oil leaks from around the oil filter or drain plug indicate incorrect installation or gasket damage. If you find any leaks or are not sure that the filter has been properly tightened, have the vehicle inspected by your SUZUKI dealer. 54G096 When replacing gear oil, use the appropriate viscosity and grade as shown in the charts below. We highly recommend you use: API GL-4 SAE 75W-90 for manual transaxle gear oil API GL-5 hypoid gear oil SAE 80W-90 for rear differential oil (i-AWD) and transfer oil of automatic transaxle model (i-AWD) 9-14 80J22-03E