2009 Suzuki SX4 Owner's Manual - Page 22

Windows: 3, 8 BEFORE DRIVING 3. Push the power door locking switch of the driver's door to the lock position. 4. Remove the key from the ignition switch and then insert it again. 5. Repeat step 4 three more times. 6. To start the engine, turn the ignition switch to the "START" position. Wait for 3 seconds. 7. Proceed to step 5) within 60 seconds after the engine has started. NOTE: You cannot program the remote controller if you don't complete steps 1 through 6 within 25 seconds. You cannot program the remote controller if you do not proceed to step 5) within 60 seconds after the engine has started. 5) Turn the ignition switch to the "LOCK" position. A buzzer will sound twice and the door lock switch will be activated from the lock position to the unlock position automatically. 6) Press the "LOCK", "UNLOCK" or "PANIC" button on the remote controller. A buzzer will sound twice and the door lock switch will be activated from the lock position to the unlock position automatically. If you want to program an additional remote controller, repeat the procedure of step 6) using the additional remote controller. NOTE: Complete step 6) within 30 seconds. You can program up to four remote controllers. 7) To complete programming, remove the key from the ignition switch or turn the ignition switch to the "ON" position. 8) Make sure that the keyless start system and keyless entry system operate properly by operating each remote controller. If you cannot operate the keyless start system and/or keyless entry system, repeat this programming procedure again. If you still cannot operate the systems, see your SUZUKI dealer. To change the old remote controller codes in your vehicle's memory If you have lost one of the remote controllers, you should change the remote controller codes in your vehicle's memory as soon as possible for security. To erase the remote controller code(s) in your vehicle's memory, you should program the new remote controller code. The old codes in your vehicle's memory will be erased automatically. If you have more remote controller(s), you must program all of the remote controller codes at the same time. You cannot operate the keyless start system and keyless entry system using any remote controller that is not programmed at the same time. For details on how to program, refer to the programming procedure in this section. When you complete programming, make sure that the keyless start system and keyless entry system operate properly by operating each remote controller. 2-9 80J22-03E