2010 Suzuki Kizashi Owner's Manual - Page 137
2010 Suzuki Kizashi Manual
Page 137 highlights
OPERATING YOUR VEHICLE on the information display when you press the engine switch to change the ignition mode to "ON". Refer to "Information Display" in the "Before Driving" section for details. For details on replacing the battery, refer to the "Keyless Start System Remote Controller" section in the "Before Driving" chapter. mode to "LOCK" (OFF) by pressing the engine switch and then perform the engine starting operation. • Always keep the remote controller with you as the driver. "Remote Controller Outside" Warning When the conditions described below are met, the system gives a "remote controller outside" warning by sounding the interior and exterior buzzers and flashing the immobilizer/keyless start system and master warning indicator lights. • The remote controller is not inside the vehicle when any of the doors is opened when the engine is running or when the engine switch is pressed to change the ignition mode to "ACC" or "ON" and then all doors are closed. • The remote controller is not inside the vehicle when you attempt to start the engine after changing the ignition mode to "ACC" or "ON" by pressing the engine switch. Interior Workable Area for Engine Starting, Power Supply Mode Selection and "Remote Controller Outside" Warning (2) (1) 57L31003 (1) Immobilizer/keyless start system warning light (flashing) (2) Master warning indicator light (flashing) NOTE: • If the warning is given, locate the remote controller as soon as possible. • Any attempt to start the engine will fail while the warning is active. The message appearing on the information display in the instrument cluster will also indicate this condition. Refer to "Information display" in the "Before Driving" section for details. • Flashing of the immobilizer/keyless start system warning light and the master warning indicator light should stop shortly after the remote controller is brought back inside the vehicle. If they do not stop flashing, change the ignition (1) 57L31004 (1) Interior workable area The "interior workable area" for these functions is defined as all the interior spaces except for the space above the instrument panel. NOTE: • Even when the remote controller is in the "interior workable area", if it is in any of 3-6