2010 Suzuki Kizashi Owner's Manual - Page 153

OPERATING YOUR VEHICLE To Set Cruising Speed 1) Turn on the cruise control system by pushing the "CRUISE" switch (1). When the "CRUISE" indicator light comes on, you can set cruising speed. 2) Accelerate or decelerate to the desired speed. 3) Push down the "RES +/SET -" switch (3) and turn on the "SET" indicator light. Take your foot off the accelerator pedal and the set speed will be maintained. "SET" indicator light NOTE: For CVT vehicle, when the cruising speed is maintained, you cannot decelerate by using the engine brake if you downshift from higher gear to 3rd in the manual mode. To decelerate while the cruise control is on, depress the brake pedal or push down the "RES +/SET -" switch (3). To Change Cruising Speed Using the accelerator pedal To reset at a faster cruising speed, accelerate to the desired speed using the accelerator pedal and push down the "RES +/SET -" switch (3). The new speed will be maintained. Using the brake pedal To reset at a slower cruising speed, decelerate to the desired speed using the brake pedal and push down the "RES +/SET -" switch (3). The new speed will be maintained. NOTE: When the brake pedal is depressed, the "SET" indicator light goes off until reset the cruising speed. Using the cruise control switch To reset at a faster cruising speed, press repeatedly or hold push up the "RES +/ SET -" switch (3). Vehicle speed will 65D474 WARNING If the cruising speed is set by accident, you cannot decelerate or could loose control of the vehicle. This could lead to an accident, resulting in severe injury or death. Turn off the cruise control system and make sure the "CRUISE" indicator light is off when the system is not in use. "CRUISE" indicator light When the vehicle's speed is controlled by the cruise control system, a "SET" indicator light on the instrument cluster will be on. To Change Speed Temporarily When the cruising speed is maintained, you can temporarily accelerate or decelerate. To accelerate, depress the accelerator pedal. When you take your foot off the pedal, your vehicle will return to the set speed. To decelerate, depress the brake pedal. The set speed will be canceled and "SET" indicator light will go off. To resume the previously set speed, push up the "RES +/SET -" switch (3) and turn on the "SET" indicator light again when vehicle speed is above 25 mph (40 km/h). The vehicle will accelerate to and maintain the previously set speed. 52D113 When you push the "CRUISE" switch, the system is on and a "CRUISE" indicator light on the instrument cluster will be on. 3-22