2010 Suzuki Kizashi Owner's Manual - Page 154

OPERATING YOUR VEHICLE steadily increase. When you release the switch, the new speed will be maintained. To reset at a slower cruising speed, press repeatedly or hold push down the "RES +/ SET -" switch (3) until the vehicle has slowed to the desired speed, then release the switch. The new speed will be maintained. NOTE: You can adjust the set speed by approximately 1.0 mph (1.6 km/h) by pushing a cruise control switch quickly. Cancellation of the Cruise Control The "SET" indicator light will go off and the cruise control will be canceled temporarily with following procedures: • Push the "CANCEL" switch (2). • Depress the brake pedal. • For manual transaxle, depress the clutch pedal. • For CVT, downshift from 3rd to 2nd in the manual mode. • The vehicle speed falls more than about 20 percent from the set speed. • Any time the vehicle speed falls below 25 mph (40 km/h). • When the vehicle skids and ESP® (if equipped) is activated. To resume the previously set speed, push up the "RES +/SET -" switch (3) and turn on the "SET" indicator light. Besides, the vehicle speed has to be above 25 mph (40 km/h) when the vehicle is not in the above conditions. To turn off the cruise control system, push the "CRUISE" switch (1) and make sure the "CRUISE" indicator light is off. Also, if the malfunction indicator light in the instrument cluster comes on or blinks, the cruise control system will be turned off. NOTE: If you turn off the cruise control system, the previously set speed in the memory is cleared. Reset your cruising speed again. Parking Sensors (if equipped) (1) 57L40019 (1) Symbol representing an obstacle detected by parking sensor* * This symbol represents an obstacle that is located to the right rear at the vehicle. • The parking sensor system uses ultrasonic sensors to detect obstacles near the rear bumper. If obstacles are sensed while you are parking or moving the vehicle slowly, the system warns you by sounding a buzzer and displaying symbols representing the obstacles on the information display in the instrument cluster. • The system emits an ultrasonic wave and the relevant sensor detects the return of the wave reflected by an obstacle. The system measures the time 3-23