2010 Suzuki Kizashi Owner's Manual - Page 26

BEFORE DRIVING EXAMPLE (1) (2) (3) (4) When the doors are unlocked: • The turn signal lights will flash twice. • If the interior light switch is in the "DOOR" position, the interior light will turn on for about 15 seconds and then fade out. If you press the engine switch during this time, the light will start to fade out immediately. Be sure the doors are locked after you operate the "LOCK" button (1). If no door is opened within about 30 seconds after the "UNLOCK" button (2) is operated, the doors will automatically lock again. NOTE: • The maximum operating distance of the remote controller is about 5 m (16 ft.), but this can vary depending on the surroundings, especially near other transmitting devices such as radio towers or CB (Citizen's Band) radios. • The door locks cannot be operated with the remote controller if the ignition mode has been changed to "LOCK" (OFF) with the engine switch, or if any door is open. If any door is open, you cannot lock the door by operating the remote controller, however unlock the door. • You cannot lock the door unless all of the door are closed completely. • If you lose one of the remote controllers, ask your SUZUKI dealer as soon as possible for a replacement. Be sure to have your dealer program the new remote controller code in your vehicle's memory so that the old code is erased. "TRUNK LID UNLOCK" button (3) function Push and hold the "TRUNK LID UNLOCK" button pressed for more than 1 second; the trunk lid will be unlatched and open slightly. NOTE: The trunk lid cannot be operated with the remote controller if the engine switch is in any other ignition mode than "LOCK" (OFF). "PANIC" button (4) function This function is to get the attention of others. Press the "PANIC" button (4) for more than 1 second. The headlights and taillights will blink for about 30 seconds. Also, the horn will sound intermittently for about 30 seconds at the same time. To cancel the "PANIC" mode, press any button (PANIC, LOCK, UNLOCK or TRUNK LID UNLOCK) on the remote controller. You can also press the engine switch to cancel the "PANIC" mode. NOTE: The "PANIC" button function will not activate when you have changed the ignition mode to "ACC" by pressing the engine switch. 57L21013 (1) (2) (3) (4) "LOCK" button "UNLOCK" button "TRUNK LID UNLOCK" button "PANIC" button "LOCK" button (1) / "UNLOCK" button (2) function You can lock or unlock all doors simultaneously by operating the remote controller near the vehicle. • To lock the doors, push the "LOCK" button (1). • To unlock the driver's door, push the "UNLOCK" button (2) once. • To unlock other doors, wait a second or two, then push the "UNLOCK" button (2) a second time. If you "double-click" too fast, the doors will not unlock. The turn signal lights will flash once when the doors are locked. 2-7