2010 Suzuki Kizashi Owner's Manual - Page 273
2010 Suzuki Kizashi Manual
Page 273 highlights
OTHER CONTROLS AND EQUIPMENT any garage door opener position manufactured before April 1, 1982). A garage door that cannot detect an object - signaling the door to stop and reverse - does not meet current U.S. federal safety standards. For more information, contact HomeLink® at www.homelink.com or by calling 1-800355-3515. Retain the original transmitter of the RF device you are programming for use in other vehicles as well as for future HomeLink® programming. It is also suggested that upon the sale of the vehicle, the programmed HomeLink® buttons be erased for security purposes. Refer to "Programming HomeLink®" (step 1) only) or, for assistance, contact HomeLink® at www.homelink.com or by calling 1-800355-3515. HomeLink® button. Begin with "Programming HomeLink®" - step 2). NOTE: Some gate operators and garage door openers may require you to replace this Programming step 3) with procedures noted in the "Gate Operator / Canadian Programming" section. 4) After the HomeLink® indicator light changes from a slow to a rapidly blinking light, release both the HomeLink® and hand-held transmitter buttons. NOTE: If the HomeLink® indicator light does not change to a rapidly blinking light, contact HomeLink® at www.homelink.com or call 1-800-355-3515 for assistance. 5) Press and hold the just-trained HomeLink® button and observe the indicator light. - If the indicator light stays on constantly, programming is complete and your device should activate when the HomeLink® button is pressed and released. NOTE: To program the remaining two HomeLink® buttons, begin with "Programming HomeLink®" - step 2). Do not repeat step 1). - If the indicator light blinks rapidly for two seconds and then turns to a constant light continue with "Programming 57L51036 Programming HomeLink® NOTE: Some vehicles may require the ignition switch to be turned to the second (or "accessories") position or the "on" position for programming and/or operation of HomeLink®. It is also recommended that a new battery be placed in the hand-held transmitter of the device being programmed to HomeLink® for quicker training and accurate transmission of the radiofrequency signal. Do not repeat "Programming HomeLink®" - step 1) to train additional devices to a second or third 1) Press and hold the two outer HomeLink® buttons (buttons one and three) - releasing only when the indicator light begins to flash (after 20 seconds). Do not hold the buttons for longer than 30 seconds and do not repeat step 1) to program a second and/or third hand-held transmitter to the remaining two HomeLink® buttons. 2) Position the end of your hand-held transmitter 5-14 cm (1-3 inches) away from the HomeLink® button you wish to program while keeping the indicator light in view. 3) Simultaneously press and hold both the chosen HomeLink® and hand-held transmitter buttons. Do not release the buttons until step 4) has been completed. 5-94