2010 Suzuki Kizashi Owner's Manual - Page 29

BEFORE DRIVING Request Switch Warning Buzzer This outside buzzer beeps for about 2 seconds in the following conditions to warn you that the request switch is not working: • The request switch is pressed after all doors are closed with the ignition mode changed to "ACC" or "ON" by pressing the engine switch. • The request switch is pressed in any of the following conditions after changing the ignition mode to "LOCK" (OFF) by pressing the engine switch. - The remote controller is left inside the vehicle. - Any of the doors is open. Press the request switch again after doing the following: With the ignition mode changed to "LOCK" (OFF) by pressing the engine switch, bring out the remote controller if it is inside the vehicle and check that all doors are completely closed. Remote Controller Reminder Function When you lock a door without using the key, this function prevents it from being locked if the remote controller is left inside the vehicle. With the remote controller inside the vehicle, locking of the driver's and passenger's doors made with the power door locking system or door lock knobs will be cancelled if either of the doors is open. NOTE: • Whenever you lock a door without using the key, check that you have the remote controller with you. This is a good habit to prevent locking a door with the remote controller left behind. • The remote controller reminder function is activated when you press the engine switch to change the ignition mode to "ACC" or "ON" anywhere the remote controller is placed. Vehicle Inside Area Where Request Switch Warning Buzzer/Remote Controller Reminder Function Works Inside the vehicle, the remote controller may be located in any place within the indicated "inside sensing area" (1) (not including the instrument panel top and trunk) for the request switch warning buzzer/remote controller reminder function to work. (1) 57L21017 2-10