2010 Suzuki Kizashi Owner's Manual - Page 346
2010 Suzuki Kizashi Manual
Page 346 highlights
EMERGENCY SERVICE WARNING (3) • Use the jack only to change wheels on level, hard ground. • Never jack up the vehicle on an inclined surface. • Never raise the vehicle with the jack in a location other than the specified jacking point (shown in the illustration) near the wheel to be changed. • Make sure that the jack is raised at least 51 mm (2 inches) before it contacts the flange. Use of the jack when it is within 51 mm (2 inches) of being fully collapsed may result in failure of the jack. • Never get under the vehicle when it is supported by the jack. • Never run the engine when the vehicle is supported by the jack and never allow passengers to remain in the vehicle. To Raise the Vehicle with a Garage Jack • Apply the garage jack to one of the points indicated below. • Always support the raised vehicle with jack stands (commercially available) at the points indicated below. (2) 57L70032 (2) Jack handle (3) Wheel brace 7) Continue to raise the jack slowly and smoothly until the tire clears the ground. Do not raise the vehicle more than necessary. 8-3