1996 Toyota Land Cruiser Owners Manual - Page 79

(e) Adjusting the sound balance To balance the sound between the right and left speakers, push the "BAL FADE" knob (if pushed in) and turn it. To balance the sound between the front and rear speakers, push the "BAL FADE" knob (if pushed in), pull it fully out and turn it. (f) Listening to the cassette tape 1. Put the cassette into the slot, with the tape side to the right and lightly push it in. The tape player will grab the cassette and slide it into place to play it. If the radio is on when inserting the cassette, the radio will automatically turn off. If the cassette is already in the slot, push the "TAPE" button. At this time, "PLAY" will appear on the display. The tape player can also be turned on by pushing the "PWR.VOL" knob if the tape player was playing when the system was turned off by pushing the knob. 2. If using a tape recorded with DolbyR NR*, push the button marked with the double-D symbol. The display will indicate that the Dolby noise reduction system is on. The Dolby NR mode reduces tape noise by about 10 dB. For best sound reproduction, play your tapes with the DolbyR NR* on or off according to the mode used for recording the tape. To play a tape recorded without DolbyR NR*, push the button again to turn off the DolbyR NR*. *: Dolby noise reduction manufactured under license from Dolby Laboratories Licensing Corporation. "DOLBY" and the double-D symbol are trademarks of Dolby Laboratories Licensing Corporation. 3. Turn the "PWR.VOL" knob to adjust the volume. 4. Select your program. (See "(g) Selecting a program".) 5. Adjust the tone and sound balance. (See "(d) Adjusting the tone" and "(e) Adjusting the sound balance".) 6. To turn the player off, push the "PWR.VOL" knob. 7. To eject the cassette, push the "EJECT" button. As this is done, the player will turn off. If the radio was on when the cassette tape was inserted, it will automatically turn on again. You can eject the cassette only once after the system is turned off. (g) Selecting a program 1. Push the "PROG" button to select a side to play. The tape operation indicator display shows you which side is being played. The player will automatically reverse directions at the end of the tape to play the other side. 2. Push the "REW FF (TUNE SEEK)" button on either side to fast forward or rewind the tape. At this time, "FF" or "REW" will appear on the display. To stop the tape while it is fast forwarding, push "FF" or "TAPE"; to stop the tape while it is rewinding, push "REW" or "TAPE". The tape will immediately begin to play. 73