1998 Toyota Land Cruiser Owners Manual - Page 234

Replacing light bulbs- The following illustrations show how to gain access to the bulbs. When replacing a bulb, make sure the ignition switch and light switch are off. Use bulbs with the wattage ratings given in the table. Light bulbs Front fog lights Parking lights Rear turn signal lights Stop and tail lights Back- up lights License plate lights Interior lights Personal lights Type A Type B Glovebox light Door courtesy lights Vanity lights W 55 51 Type A B C A B C D E : : : : : HB3 halogen bulbs HB4 halogen bulbs Single end bulbs (ambar) Wedge base bulbs Double end bulbs Bulb No. 9006 - -Headlights W 51 5 21 21/5 21 5 8 5 8 1.4 3 1.5 Type B D D D D D E C E D D E 1. Open the hood. LEFT-HAND HEADLIGHT: Remove the washer inlet. Be careful not to spill the washer fluid over the "NORMAL" level. Do not place the washer inlet on the engine or battery. CAUTION Halogen bulbs have pressurized gas inside and require special handling. They can burst or shatter if scratched or dropped. Hold a bulb only by its plastic or metal case. Do not touch the glass part of a bulb with bare hands. 7440 7443 7440 NOTICE Only use a bulb of the listed type. Light bulbs Head lights (high) Head lights (low) Front turn signal and front side marker lights Bulb No. 9005 9006 1157NA 27/8 234