1998 Toyota Tacoma Owners Manual - Page 160

1998 Toyota Tacoma Manual

Page 160 highlights

'98 Tacoma (U) D In order to maintain engine braking efficiency, do not use fifth gear (manual transmission) or overdrive (automatic transmission). 4. Apply the parking brake firmly. 5. Shift into first or reverse (manual) or "P" (automatic) and turn off the engine. When restarting out after parking on a slope: 1. With the transmission in "P" position (automatic) or the clutch pedal depressed (manual), start the engine. (With an automatic transmission, be sure to keep the brake pedal depressed.) 2. Shift into gear. 3. Release the parking brake (also foot brake on automatic transmission vehicles) and slowly pull or back away from the wheel blocks. Stop and apply your brakes. 4. Have someone retrieve the blocks. CAUTION D Do not exceed 72 km/h (45 mph) or the posted towing speed limit, whichever is lower. Because instability (swaying) of a towing vehicletrailer combination usually increases as the speed increases, exceeding 72 km/h (45 mph) may cause loss of control. D Because of the added load of the trailer, your vehicle's engine may overheat on hot days (at temperatures over 30°C [85°F]) when going up a long or steep grade with a trailer. If the engine coolant temperature gauge indicates overheating, immediately turn off the air conditioning (if in use), pull off the road and stop in a safe spot. Refer to "If your vehicle overheats" in Part 4 of this manual. D Slow down and downshift before descending steep or long downhill grades. Do not make sudden downshifts. D Always place wheel blocks under both the vehicle and trailer wheels when parking. Apply the parking brake firmly. Put the transmission in "P" (automatic) or in first or reverse (manual). Avoid parking on a slope with a trailer, but if it cannot be avoided, do so only after performing the following: 1. Apply the brakes and hold. 2. Have someone place wheel blocks under both the vehicle and trailer wheels. 3. When the wheel blocks are in place, release your brakes slowly until the blocks absorb the load. D Avoid holding the brake pedal down too long or too frequently. This could cause the brakes to overheat and result in reduced braking efficiency. 160

We apologize, but we cannot currently deliver this PDF manual by request of the manufacturer.

We apologize for any inconveniece.