1999 Toyota Solara Owners Manual - Page 143

SOLARA_U PROGRAMMING OPENER THE GARAGE DOOR This garage door opener has 3 buttons and you can store one program for each button. 1. Decide which one of the 3 buttons you want to program. Push and hold down one of the buttons until its indicator light begins to flash. 2. While holding this button, bring the original garage door opener closer to the garage door opener equipped on the vehicle within about 25 mm (1 in.) and push the button on the original garage door opener. This signal from the original garage door opener is sent to the one to be programmed. 3. When the frequency and code is registered, the indicator light flashes rapidly. Then you can release both buttons. 4. If you wish, repeat the procedure for each remaining button for another garage door opener. If you want to write a new program over the program set already, select a button you want to program and repeat the procedure from step 1. The previous program is erased and a new program will be set. If the transmitter has a "rolling code" feature, it is necessary to program the garage door opener receiver on the garage after programming the garage door opener on the vehicle. For the setting of the receiver, refer to the instruction manual for the receiver. After setting the receiver, push the programmed button on the vehicle for about 1 to 2 seconds within the operational range. The old- type garage door openers manufactured before 1982 cannot be programmed with this system. ERASING THE GARAGE DOOR OPENER MEMORY Push and hold down the 2 outside buttons until the indicator light flashes. All memorized data will be erased. FCC ID: CB2V94800 CANADA: 1763 102 264 This device complies with FCC Rules part 15. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference that may be received, including interference that may cause undesired operation. WARNING: This transmitter has been tested and complies with FCC and DOC/MDC rules. Changes or modifications not expressly approved by the partly responsible for compliance could void the user's authority to operate the device. CAUTION When programming or operating the garage door opener, make sure there is no one around the moving door. It is dangerous if someone is caught. OPERATING OPENER THE GARAGE DOOR Push the appropriate button to activate the garage door opener. The indicator light comes on. The garage door opener continues to send the signal for up to 20 seconds as long as the button is pushed. 143