2000 Toyota Corolla Owners Manual - Page 110

2000 Corolla(U) 1 2 3 4 5 6 (Preset buttons) These buttons are used to preset and tune in radio stations. To preset a station to a button: Tune in the desired station (see "TUNE" button). Push and hold down the button until you hear a beep-this will set the station to the button. The button number will appear on the display. To tune in to a preset station: Push the button for the station you want. The button number and station frequency will appear on the display. These systems can store one AM and one FM station for each button. The preset station memory will be canceled out if the power source is interrupted (battery disconnected or fuse blown). AM·FM Push "AM·FM" to switch between the AM and FM bands. "AM" or "FM" will appear on the display. If the audio system is off, you can turn on the radio by pushing "AM·FM". BAL (Balance) Turn the "BAL" knob with pulling to adjust the balance between the right and left speakers. PWR·VOL (Power·Volume) Push "PWR·VOL" to turn the audio system on and off. Turn "PWR·VOL" to adjust the volume. ST (Stereo reception) display Your radio automatically changes to stereo reception when a stereo broadcast is received. "ST" appears on the display. If the signal becomes weak, the radio reduces the amount of channel separation to prevent the weak signal from creating noise. If the signal becomes extremely weak, the radio switches from stereo to mono reception. TONE Move the "TONE" ring around "BAL" to adjust the tone. TUNE Tuning Your Toyota has an electronic tuning radio (ETR). Push and release the " Ɯ" (up) or " Ɲ" (down) side of "TUNE" to step up or down the station band. (If you hear a beep, you held the button too long and the radio will go into the seek mode.) Seeking In the seek mode, the radio finds and plays the next station up or down the station band. To seek a station, push and hold the "Ɯ" or "Ɲ" side of "TUNE" until you hear a beep. Do this again to find another station. 110