2000 Toyota Corolla Owners Manual - Page 18

2000 Corolla(U) Stopping the alarm Turn the ignition key from the "LOCK" to "ON" position. The alarm will be stopped with the starter circuit cut kept on. Stopping the alarm in this manner will keep the alarm from being reactivated when any of the doors, trunk or hood is opened. Interrupting the setting With the system set, the trunk can be opened with the key without activating or cancelling the system. While it is open, the doors and hood may be opened in addition. However, when the battery terminal is disconnected and then reconnected, the system is activated. To resume the setting, close and lock all the doors, trunk and hood. The trunk must be closed with the key removed. CANCELLING THE SYSTEM Unlock either front door with the key. This cancels the system completely and the starter circuit cut will be cancelled at once. INDICATOR LIGHT The indicator light three indications. gives the following TESTING THE SYSTEM 1. Open all the windows. 2. Set The key. light the system as described above. doors should be locked with the Be sure to wait until the indicator starts flashing. FLASHING-The system is set. You need the key to open the doors, trunk and hood. ON-The system will automatically be set when the time comes. The doors, trunk and hood may be opened without a key. OFF-The system is inactive. You may open any door, trunk and hood. 3. Unlock any door from the inside. The system should activate the alarm. 4. Cancel the system by unlocking any of the doors with the key. 5. Repeat this operation for the other doors, trunk and hood. When testing on the hood, also check that the system is activated when the battery terminal is disconnected and then reconnected. If the system does not work properly, have it checked by your Toyota dealer. 18