2001 Toyota Sequoia Owners Manual - Page 15

01_SEQUOIA_U (L/O 0009) Your vehicle has a wireless remote control system that can lock or unlock all the side doors and back door from a distance within approximately 1 m (3 ft.) of the vehicle. LOCKING AND UNLOCKING THE SIDE DOORS AND BACK DOOR To lock and unlock all the side doors and back door, push the switches slowly and securely. To lock: Push the "LOCK" side doors and back door multaneously. At this time be heard, and the parking lights flash once. switch. All the are locked sione beep will lights and tail To unlock: Push the "UNLOCK" switch once to unlock the driver's door alone. Pushing the switch twice within 3 seconds unlocks all the side doors and back door simultaneously. Each time the "UNLOCK" switch is pushed, two beeps will be heard, and the parking lights and tail lights flash twice. This double switch operation to unlock all the side doors and back door can be changed to a single switch operation. For details, contact your Toyota dealer. When all the side doors and back door are unlocked simultaneously with a wireless remote control transmitter, the interior light, luggage compartment light, ignition switch light and foot light come on for about 15 seconds and then fade out, even if the door is not opened. (For details, see "Center interior and personal light" on page 115, "Luggage compartment light" on page 116 and "Ignition switch light" on page 117 in Section 1 −4.) You have 30 seconds to open a door after using the wireless remote unlock feature. If a door is not opened by then, all the side doors and back door will be automatically locked again. The timing for the automatic door lock function can be changed. For details, contact your Toyota dealer. If the "LOCK" or "UNLOCK" switch is kept pressed in, the locking or unlocking operation is not repeated. Release the button and then push again. The wireless door locking or unlocking function can be erased. For details, contact your Toyota dealer. SWITCHING BEEP SOUND ON AND OFF You can switch the beep on and off. (The beep is on initially and after battery replacement.) To switch the beep on and off: With the driver's door opened- 1. Insert the ignition key and remove it. 2. Within 5 seconds, insert the ignition key again and turn it to the "ON" position. 3. After 10 seconds, push the same "LOCK", "UNLOCK" or "PANIC" button twice within 10 seconds. Two beep sounds inform you that the program has been switched on or off. If this procedure is not followed exactly, the beep will not operate as expected. Check to see that all the side doors and back door are securely locked. If any of the side doors or back door is not securely closed, locking cannot be performed by the "LOCK" switch and a beep will sound continuously for 10 seconds. However, if the key is in the ignition, a beep will not sound. To stop the buzzer, close all the doors securely or push the "UNLOCK" switch. The buzzer can be disabled. For details, contact your Toyota dealer. 2001 SEQUOIA (OM34414U) 15