2002 Toyota Avalon Owners Manual - Page 159

'02 AVALON U (L/O 0107) AM Push "AM" to turn on the radio and select the AM band. "AM" will appear on the display. If the audio system is off, you can turn on the radio by pushing "AM". Also, push "AM" to switch from cassette or compact disc operation to AM. AUDIO CTRL / MODE (Audio control and mode adjustment) Each time you push the AUDIO CONTROL knob, the mode changes. To adjust the tone and balance, turn the knob. BASS: Adjusts low−pitched tones. The display ranges from −5 to 5. MID: Adjusts mid−pitched tones. The display ranges from −5 to 5. TREBLE: Adjusts high−pitched tones. The display ranges from −5 to 5. BALANCE: Adjusts the sound balance between the right and left speakers. The display ranges from −7 to 7. FADER: Adjusts the sound balance between the front and rear speakers. The display ranges from −7 to 7. CD (Compact Disc) Push "CD" while in radio or cassette mode to switch to compact disc mode. If the audio system is off, pressing "CD" will turn on the compact disc player. A disc must be loaded in the player. When the audio is set into compact disc operation, the display shows the track or, track and disc number currently being played. If the player or another unit equipped with the player malfunctions, your audio system will display one of the six following error messages. Error codes "WAIT": The compact disc player unit may be too hot due to temperature. Allow the player to cool down. "ERR 1": The disc may be dirty, damaged or inserted incorrectly (up−side down). Clean disc and re−insert. "ERR 2": The compact disc player is empty. Load disc and re−try. "ERR 3" or "ERR 4": This indicates internal error. Re−load discs. "OPEn": The compact disc auto changer lid is open. Close the compact disc auto changer lid. If the malfunction still exists, take your vehicle to your Toyota dealer. DISC By using this button, you can select a disc you wish to listen to. Push either side of the button until the number of the disc you want to listen appears on the display. Dolbyr B NR∗ If you are listening to a tape that was recorded with Dolbyr B Noise Reduction, push the button marked with the double−D symbol. The double−D symbol will appear on the display. Push the button again to turn off Dolbyr B NR. The Dolby NR mode reduces tape noise by about 10 dB. For best sound reproduction, play your tapes with this button on or off according to the mode used for recording the tape. : Dolby noise reduction manufactured under license from Dolby Laboratories Licensing Corporation. "DOLBY" and the are trademarks of Dolby Laboratories double D symbol Licensing Corporation. ∗ 158 2002 MY AVALON_U (OM22493U)