2002 Toyota Avalon Owners Manual - Page 196

'02 AVALON U (L/O 0107) Programming a rolling code system If your device is "Rolling Code" equipped, it is necessary to follow steps 1 through 4 under the heading "Programming the HomeLinkR" before proceeding with the steps listed below. 1. Locate the "training" button on the ceiling mounted garage door opener motor. The exact location and color of the button may vary by brand of garage door opener. Refer to the owner's guide supplied by the garage door opener manufacturer for the location of this "training" button. 2. Press the "training" button on the ceiling mounted garage door opener motor. Following this step, you have 30 seconds in which to initiate step 3 below. 3. Press and release the vehicle's programmed HomeLinkR button twice. The garage door may open. If the door does open, the programming process is complete. If the door does not open, press and release the button a third time. This third press and release will complete the programming process by opening the garage door. The ceiling mounted garage door opener motor should now recognize the HomeLinkR unit and be able activate the garage door up/down. 4. Repeat steps 1 through 3 for each remaining HomeLinkR button to program another rolling code system. Programming an entrance gate/Programming all devices in the Canadian market 1. Decide which of the 3 HomeLinkR buttons you want to program. 2. Place your hand−held gate/device transmitter 25 to 75 mm (1 to 3 in.) away from the surface of the HomeLinkR. Keep the indicator light on the HomeLinkR in view while programming. 3. Press and hold HomeLinkR button. the selected 6. Test the operation of the HomeLinkR by pressing the newly programmed button. Check to see if the gate/device operates correctly. 7. Repeat steps 1 through 6 for each remaining HomeLinkR button to program another device. Programming other devices To program other devices such as home security systems, home door locks or lighting, contact your authorized Toyota dealer for assistance. Reprogramming a button buttons cannot be Individual HomeLinkR erased, however, to reprogram a single button, follow the procedure "Programming the HomeLinkR". (b) Operating the HomeLinkR To operate the HomeLinkR, press the appropriate HomeLinkR button to activate the programmed device. The HomeLinkR indicator light should come on. The HomeLinkR continues to send the signal for up to 20 seconds as long as the button is pressed. 4. Continuously press and release (cycle) the hand−held gate/device transmitter button every two seconds until step 5 is complete. 5. When the indicator light on the HomeLinkR changes from a slow to a rapid flash after 20 seconds, you can release both buttons. 2002 MY AVALON_U (OM22493U) 195