2002 Toyota Sequoia Owners Manual - Page 30

02_SEQUOIA_U (L/O 0108) The system will automatically be set after 30 seconds. When the system is set, the indicator light will start flashing again. 4. After making sure the indicator light starts flashing, you may leave the vehicle. Never leave anyone in the vehicle when you set the system, because unlocking from the inside will activate the system. WHEN THE SYSTEM IS SET Activating the system SETTING THE SYSTEM 1. Turn the ignition key to the "LOCK" position and remove it. The indicator light will start flashing when the key is removed from the ignition switch. (See "Engine immobiliser system" on page 10 for details.) 2. Have all passengers get out of the vehicle. 3. Close and lock all the side doors, back door and hood. The indicator light will come on when all the side doors, back door and hood are closed and locked. The system will give the alarm under the following conditions: If the alarm has been activated and the key is not in the ignition switch, all the side doors and back door will re−lock automatically. After one minute, the alarm will automatically stop and the indicator light will starts flashing again. Reactivating the alarm Once set, the system automatically resets the alarm after the alarm stops. The alarm will activate again under the same circumstances described in "Activating the system". Stopping the alarm The alarm will be stopped by the following two ways: D If any of the side doors is unlocked or opened without the key or wireless remote control transmitter, or if the back door or hood is forcibly opened D Turn the ignition key from the "LOCK" to "ON" position. D If the battery terminal is disconnected and then reconnected The indicator light will come on when the system is activated. D Unlock any of the side doors or back door with the key or wireless remote control transmitter. These ways cancel the system at the same time. 30 2002 MY SEQUOIA_U (OM34418U)