2003 Toyota Land Cruiser Owners Manual - Page 519

'03 L/C U (L/O 0301) Before starting the engine 1. Check the area around the vehicle before entering it. 2. Adjust seat position, seatback angle, head restraint height and steering wheel angle. 3. Adjust the inside and outside rear view mirrors. 4. Lock all doors. 5. Fasten seat belts. How to start the engine- (a) Cranking hold function Once you turn the ignition key to "START" position and release it, the cranking hold function continues to crank the engine in "ON" position until it starts. The function stops cranking the engine after about 25 seconds maximum if the engine has not started yet. When you crank the engine again, wait a few seconds and restart it. If you hold the key in "START" position, the function will keep cranking for about 30 seconds maximum. (c) Starting the engine Before starting the engine, be sure to follow the instructions in "(b) Before cranking". Normal starting procedure The multiport fuel injection system/sequential multiport fuel injection system in your engine automatically controls the proper air-fuel mixture for starting. You can start a cold or hot engine as follows: 1. With your foot off the accelerator pedal, turning the ignition key to "START" position, then release it. 2. After the engine runs for about 10 seconds, you are ready to drive. If the weather is below freezing, let the engine warm up for a few minutes before driving. If the engine stalls...Simply restart it, using the correct procedure given in normal starting. If the engine will not start...See "If your vehicle will not start" on page 226. (b) Before cranking 1. Apply the parking brake firmly. 2. Turn off unnecessary lights and accessories. 3. Put the selector lever in "P". If you need to restart the engine while the vehicle is moving, put the selector lever in "N". A starter safety device will prevent the starter from operating if the selector lever is in any drive position. 4. Depress the brake pedal and hold it to the floor until driving off. 210